The Sewing Place

Rotary Cutter Novice


Rotary Cutter Novice
« on: June 12, 2017, 19:33:33 PM »
I`ve had a Clover rotary cutter for a while and was disappointed that it became blunt quickly.
 I`ve just put in a new blade and have now realised that when I cut with it the blade isn`t turning round - so the same bit of it is being used all of the time and getting blunt whilst the rest remains unused.
 The instructions are to tighten the screw tightly but have I got it too tight? Or should I be trying to move the blade round a bit manually (risking injury)?


Re: Rotary Cutter Novice
« Reply #1 on: June 12, 2017, 19:38:46 PM »
Can you post a picture? At some point I put a washer or something the wrong way and the blade was stuck. It's definetly supposed to rotate when you cut. Do not try to move it manually, it's of no use anyway and you risk cutting yourself.
I also got 10 blades from ebay for like 2 pounds. Very good deal.
Dogs have owners. Cats have staff.


Re: Rotary Cutter Novice
« Reply #2 on: June 12, 2017, 19:53:54 PM »
After playing around with it a bit (carefully!), I reckon I had got the screw too tight.  The instructions say "Remember to tighten the screw firmly" and I think I have been doing it too firmly!

I am now cross with myself because I am wondering if I did the same with the first blade and it was actually only blunt in one section


Re: Rotary Cutter Novice
« Reply #3 on: July 15, 2017, 12:58:35 PM »
You can sharpen rotary cutter blades, easily and cheaply. It won't get rid of burrs and nicks caused by rolling it over a pin but it'll sharpen a blunt blade nicely.

Take a piece of aluminium kitchen foil (about A4 size) and fold it multiple times so it's a thickish wodge of foil - four to six layers, probably.

Place on your cutting mat and cut into it with the rotary cutter and blunt blade. After about a dozen swipes, your blade will be nice and sharp and the foil will be shredded (AND DEADLY - this is the bit I always cut myself on so dispose of VERY carefully).

I've had the same blade in my cutter for a year and a half now.  Saved myself a fortune!
  • Jo likes this


Re: Rotary Cutter Novice
« Reply #4 on: July 15, 2017, 16:48:25 PM »
That has the additional advantage of sounding as though it would be FUN!   0_0
I might look as though I'm talking to you, but inside my head I'm sewing.