The Sewing Place

Issue with brother innovis cs8080

annieeg

Issue with brother innovis cs8080
« on: June 14, 2019, 19:04:49 PM »
I'm struggling with some very faulty machining which  is caused by the bobbin (I.e., it's the underside). The underside of the stitching is about 0.3 cm loose from the needle side.
Would anyone know what might be causing this?
I'll try and post a photo later.
Annie

Celia

Re: Issue with brother innovis cs8080
« Reply #1 on: June 14, 2019, 19:31:04 PM »
If the problem is showing underneath it is usually the top thread that is causing a problem, try unthreading and threading again and check the tension.
Hope this helps

annieeg

Re: Issue with brother innovis cs8080
« Reply #2 on: June 14, 2019, 20:01:21 PM »
@Celia
Thank you -I'm mortified to say it didn't occur to me to check tension  :ninja:
I'll do that and report updates.

annieeg

Re: Issue with brother innovis cs8080
« Reply #3 on: June 14, 2019, 22:36:02 PM »
Here's a photo of the stitching issue.
  [ You are not allowed to view attachments ]  

Lilian

Re: Issue with brother innovis cs8080
« Reply #4 on: June 14, 2019, 23:13:26 PM »
@annieeg I wonder if there is lint around the bobbin case, I had that happen a few days ago so cleaned out the feed dogs and bobbin case, checked tension on bobbin and upper thread.  It worked well after that.  :vintage:
Willing but not always able :)

annieeg

Re: Issue with brother innovis cs8080
« Reply #5 on: June 14, 2019, 23:31:05 PM »
@Lilian thanks for the suggestion  and I wl check that out.