I had some problem with armhole gaping that I asked about recently. I cut a smaller size in the upper front bodice, but when i made the toile, the armhole gaping was the same. I put on my previous toile (prior to this one) and pinched the shoulder slope some and the armhole gaping went away. I did not need any adjustment on the back armhole, so I just dropped the slope by 3/4 inch at the shoulder on the front bodice. I did this by starting at the neckline and drew the line until it was 3/4 inch lower at the shoulder seam. Then I took off the same amount under the arm on the front bodice. This way I did not have to adjust my sleeve. Two problems developed from this. First, I forgot to lengthen the side seam of the front bodice by the amount I took off the bottom of the armhole, so I know how to fix that just by adding that length back. But the one I don't know how to fix is the second problem that developed. Now, the shoulder length of the front bodice is not the same as the back bodice. When I put the shoulders together to sew the seams, they are not the same length and the difference is enough that I can't ease them together so that they match. How do I fix this problem? Thanks.